HOME      PRODUCTS      ABOUT US      NEWS      MEDIA       CONTACT

 
When the Environment Matters The Muller 3C Condenser is in essence a standard air cooled condenser with adiabatic CelPads over the face of the coils. These pads remain dry until ambient conditions reach the point that the fan alone can no longer handle the heat load. The water is switched on and the pads are dampened. This process pre cools the air before passing through the coil, increasing the efficiency of the unit.

The advantage of a 3C Condenser is the assistance given by the pads in lowering the air on temperature on to the coil cooling the air, the unit’s footprint is significantly smaller than a standard condenser with a reduced refrigerant charge. 
Muller 3C Condenser series are environmentally sustainable heat rejection systems consisting of four model ranges: 
- SH08-DF Series with 4 models for capacities 100kW HOR to 500kW HOR - H08-DF Series with 5 models for capacities from 450kW HOR to 1250kW HOR - SH09-DF Series with 3 models for capacities from 100kW to 300kW - H09-DF Series with 3 models for capacities from 300kW to 600kW 
Muller 3C Condenser with air pre-cooling was developed to replace conventional air cooled / evaporative condensers without need to alter any existing pipe work.
 Compared to Air Cooled:

- Reduced weight and footprint
- Reduced energy consumption
- Improved plant COP (lower condensing temperatures) 
Compared to Evaporative:
 No risk of Legionella - No registration required
- No need for costly chemical water treatment Reduced water consumption by up to 80% Increased life expectancy Fluid_Cooler_-_Introduction.html